Roof moisture meters for checks, leaks & flat roof inspections

From the moment a flat roof is installed, the structure should be regularly maintained and inspected. Any problems or defects must be rectified as soon as they are noticed to prevent further damage to the roof. The Tramex moisture testers for roofs provide Fast and accurate results. In addition, the Tramex roof scanners offer the Most economical and reliable method for detecting moisture damage in flat roofs.

The Dec scanner DS2 and the RWS roof and wall scanner have been developed to Moisture condition of an entire roof surface according to ASTM D7954 quickly and non-destructively to evaluate. Both devices are suitable Ideal for detecting and locating the source of a leak and to the Locating and mapping damaged insulation and roofing materials. The Tramex Roof Moisture Inspection Kits are not only suitable for the assessment of possible moisture problems, but can also be used to carry out a Integrity tests can be used on a newly installed roof system.

No special operating licences are required and the building does not need to be evacuated, and best of all, the test can be carried out at any time of day.

• ASTM D7954 compliant.
• Instant, non-destructive and continuous scanning of a large roof area saves you time and money.
• On a normal working day, up to 100,000 square metres be covered.
• Multiple sensitivity ranges enable the scanning of a wide range of roof structures and thus the inspection of both superstructures and thin-film roofs. The 3 different depth readings help to localise moisture in the roof structure.
• You can use up to 2 % detect excess moisture at a depth of up to 6 inches.
• No special operating licence required.
• Transport on the road or by plane is effortless with our robust flight case (included).

• The RWS is a hand-held device that can be used with the supplied Extension handle can also be used in "hard-to-reach" places.
• The Multiple deep penetration and the Sensitivity selection allow the user to trace leaks back to their source.
• ASTM D7954 compliant.
• Can be used for Roofs, ETICS, foam insulation systems and other applications in the building envelope.

Determine the moisture content and measure the relative humidity under the roof covering or in wall constructions. To do this, pins or probes are inserted into the surface material through small drill or puncture holes.

• The insulated pin electrodes measure the moisture content deep inside soft materialssuch as insulating materials.
• The Probes for relative ambient humidity measure the relative ambient humidity in % in roof or wall cavities.
• The Wooden pin electrodes measure the moisture content of wood and wood by-products.

This accessory can be used with the Concrete Moisture Encounter CMEX5can be used.

The Tramex Concrete Moisture Encounter CMEX5 may seem out of place in a section on roofs, but concrete or cementitious materials can also be found on flat roofs.

The CMEX5 moisture analyser has the additional advantage that it can measure the Ambient conditions with the built-in Hygro-i2 sensor can measure.

It also has a bayonet connection for Optional accessories such as needle probes and sensors for relative humidity.

• Non-destructive testing of concrete and cementitious materials with immediate results.
• Immediate reading of ambient conditions and temperature.
• The optional Bayonet plug-in connection extends the measurement options:
  - Review of the Moisture content in insulation materials with Tramex electrodes.
  - Measure the Ambient conditions in cavities of roof and wall constructions with Tramex probes for relative humidity.
  - Determine the Moisture content of wood with Tramex pin probes.
• Save Measured values and geotag locations in reports with the Tramex Meters app.